Transmission1

Every time I try use HSDR it comes up with this?

Did you do as it says? Was it working and then stopped?

I did and when I do try to start it,I get this now...

It eventually starts but still no stations.

this mayhelp ,also admiral has give you the file,viewtopic.php?f=3&t=53762

the file does nothing at all..it's just the same..no station pick at all.
but sdr radio picks everything up,hdsdr used to but it just hisses away now..very sad as this used to be the best one.
this happens now.

If you've had a Windows update recently then consider running zadig again to refresh the driver.

Woo got it working with a few problems..I have to use LSB on 20mtrs this can't be right surely?
And volume very low.

20 meters is LSB you only go into USB from about 10 meters. Lower frequencies are generally LSB higher frequencies generally USB

I don't wish to sound pedantic, but for amateur use the SSB rule-of-thumb is LSB below 10Mhz and USB above 10Mhz on HF, so 20m SSB phone would generally be USB.

Ah OK admiral I thought it was something like that I was forgetting 20 is 14 meg

Is there any way I can get it to go louder Admiral?

Apart from the obvious volume control just below the tune frequency, or making sure you have at least one AGC on when you click the ExtIO button to the right of the tune frequency (I run with both ticked) then I'm stumped mate.

Got everything working sdr and now this happens!
any ideas?.