Wire off in Nato 2000 help please

[163TM847]

Could some kind Nato 2000 owner have a look at the wire located on the expansion/beep board [Marked in red square in attached image] and trace it back to where it goes please.

Thanks

DSC01047.JPG

[163TM847]

I guess no one owns a Nato 2000 on here.

[cb4ever104]

I guess no one owns a Nato 2000 on here.

I don't , or a would have replied . I'm sure someone must have one ...

[Buick Mackane]

Can you not trace it on the schematic ?

[163TM847]

Done now, It was the beep audio output wire, But beep was feed backing through speaker, Q603 was blown so there was no delay to the relay, Which would explain why the wire was cut off.

Can you not trace it on the schematic ?

Schematic never seems to include the Expansion/Beep board as it was only the Nato 2000 that had it.

[cubwolf]

I know you have sussed it but in case you need it in the future the Nato 2000 schematic and one for the Sub PCB can be found here https://1drv.ms/f/s!AiFwsALeEFbbrNUbPH4JU8Ok8GEBSg

[The Collector]

Glad you got it sorted Nick. I was all set to take mine off the shelf and take the cases off for you over the weekend. I can relax again now as I'm not feeling too good at all and I wasn't looking forward to a trip up into the loft

I've got 2 Nato 2k's (a standard one and my copper-coloured one) so if you should need anything picture-wise in the future, then let me know mate.

[Moreupsthandownz]

A bit late to the party but here, radio is packed away but I had a couple of internal photos from a few months back.

Simon