Page 1 of 1

Software Kenwood TK3101 no need DOS , run to Windows !!!

Posted: 15 Aug 2017, 21:24
by rooth
Software Kenwood TK3101 no need DOS , run to Windows !!! :D :D :D
Interface KPG22 serial .
-Press and hold PTT and MONITOR Key (button under PTT) then switch ON the radio
-Continue to hold both buttons until the LED lights orange then release
-Press the MONITOR button the orange LED changes to RED and a beep sounds.
-Radio is now in tone setup mode !

Re: Software Kenwood TK3101 no need DOS , run to Windows !!!

Posted: 16 Aug 2017, 08:39
by 310den
Thanks for this. Will try it later. Got to be better than using the older software via DOS. Did you develop this? Will you be doing others for similar radios?

:thumbup:

Re: Software Kenwood TK3101 no need DOS , run to Windows !!!

Posted: 16 Aug 2017, 12:46
by rooth
Hello 310den !
Last night I found the software and I successfully used it on the TK3101.

Re: Software Kenwood TK3101 no need DOS , run to Windows !!!

Posted: 16 Aug 2017, 13:21
by 310den
rooth wrote:Hello 310den !
Last night I found the software and I successfully used it on the TK3101.
OK thanks, good find. I will be using it later.