Software Kenwood TK3101 no need DOS , run to Windows !!!

Here you can discuss Datamodes for all bands (PSK31, FT8, JS8Call, etc), Software Defined Radio topics & General Radio Software or apps
Post Reply
User avatar
rooth
Regular
Regular
Posts: 55
Joined: 27 Mar 2017, 19:29
Location: Roma

Software Kenwood TK3101 no need DOS , run to Windows !!!

Post by rooth »

Software Kenwood TK3101 no need DOS , run to Windows !!! :D :D :D
Interface KPG22 serial .
-Press and hold PTT and MONITOR Key (button under PTT) then switch ON the radio
-Continue to hold both buttons until the LED lights orange then release
-Press the MONITOR button the orange LED changes to RED and a beep sounds.
-Radio is now in tone setup mode !
You do not have the required permissions to view the files attached to this post.
User avatar
310den
Radio Addict
Radio Addict
Posts: 946
Joined: 21 Jun 2011, 18:52
Location: West Sussex
Contact:

Re: Software Kenwood TK3101 no need DOS , run to Windows !!!

Post by 310den »

Thanks for this. Will try it later. Got to be better than using the older software via DOS. Did you develop this? Will you be doing others for similar radios?

:thumbup:
User avatar
rooth
Regular
Regular
Posts: 55
Joined: 27 Mar 2017, 19:29
Location: Roma

Re: Software Kenwood TK3101 no need DOS , run to Windows !!!

Post by rooth »

Hello 310den !
Last night I found the software and I successfully used it on the TK3101.
User avatar
310den
Radio Addict
Radio Addict
Posts: 946
Joined: 21 Jun 2011, 18:52
Location: West Sussex
Contact:

Re: Software Kenwood TK3101 no need DOS , run to Windows !!!

Post by 310den »

rooth wrote:Hello 310den !
Last night I found the software and I successfully used it on the TK3101.
OK thanks, good find. I will be using it later.
Post Reply