Software Kenwood TK3101 no need DOS , run to Windows !!!
Interface KPG22 serial .
-Press and hold PTT and MONITOR Key (button under PTT) then switch ON the radio
-Continue to hold both buttons until the LED lights orange then release
-Press the MONITOR button the orange LED changes to RED and a beep sounds.
-Radio is now in tone setup mode !
Software Kenwood TK3101 no need DOS , run to Windows !!!
- rooth
- Regular
- Posts: 55
- Joined: 27 Mar 2017, 19:29
- Location: Roma
Software Kenwood TK3101 no need DOS , run to Windows !!!
You do not have the required permissions to view the files attached to this post.
- 310den
- Radio Addict
- Posts: 946
- Joined: 21 Jun 2011, 18:52
- Location: West Sussex
- Contact:
Re: Software Kenwood TK3101 no need DOS , run to Windows !!!
Thanks for this. Will try it later. Got to be better than using the older software via DOS. Did you develop this? Will you be doing others for similar radios?
- rooth
- Regular
- Posts: 55
- Joined: 27 Mar 2017, 19:29
- Location: Roma
Re: Software Kenwood TK3101 no need DOS , run to Windows !!!
Hello 310den !
Last night I found the software and I successfully used it on the TK3101.
Last night I found the software and I successfully used it on the TK3101.
- 310den
- Radio Addict
- Posts: 946
- Joined: 21 Jun 2011, 18:52
- Location: West Sussex
- Contact:
Re: Software Kenwood TK3101 no need DOS , run to Windows !!!
OK thanks, good find. I will be using it later.rooth wrote:Hello 310den !
Last night I found the software and I successfully used it on the TK3101.