Re: DSD-S**t Sorry I mean DSD+
Posted: 13 Nov 2016, 13:24
OK here you go.
Download the zip file called SDRRadio.zip and unpack it to your desktop.
When Unpacked you should have a folder called SDRRadio all of the SDR# Stuff will be inside this folder.
To run SDR# open the folder SDRRadio then open the folder called SDR# and click on SDRSharp.exe.
The folder called SDR# has everything already installed Including DSD+ etc etc and is where you will use SDR# from.
The other two folders are self explanatory.
"Only used when you first install SDR#" this folder contains all of the unzipped stuff needed after a fresh installation of SDR# and I have included a INSTALLATION INSTRUCTIONS.txt file where necessary.
"Original Installation Zipped Files" This folder contains all of the original zipped files including SDR# all renamed by me so you know what is what.
Some Points To NOTE:
You will find that I have started to tidy up the Band Plan in my SDR# for the UK because the one that comes with SDR# is a complete mess and I think was made for people in the USA as opposed to the UK you can just replace that with the original should you not like it.
I have also added New Groups to the Frequency Manager these are Frequencies I have found in my own area (Leicester) so may or may not be active in your area, the Groups I have added are.
FM Radio (FM Radio Stations)
2M HAM (So far just 1 2m Ham Frequency)
security (Lots of active DMR, PMR channels etc that are in my area, ranging from about 446 - 460 mHz)
Again you can remove the Frequencies from a group or regroup them all from inside SDRSharp's Frequency Manager, see the icons at the top of the Frequency Manager.
Enjoy.
OK the forum says the file is to large so I will upload it to my server and PM you a link to download it
Download the zip file called SDRRadio.zip and unpack it to your desktop.
When Unpacked you should have a folder called SDRRadio all of the SDR# Stuff will be inside this folder.
To run SDR# open the folder SDRRadio then open the folder called SDR# and click on SDRSharp.exe.
The folder called SDR# has everything already installed Including DSD+ etc etc and is where you will use SDR# from.
The other two folders are self explanatory.
"Only used when you first install SDR#" this folder contains all of the unzipped stuff needed after a fresh installation of SDR# and I have included a INSTALLATION INSTRUCTIONS.txt file where necessary.
"Original Installation Zipped Files" This folder contains all of the original zipped files including SDR# all renamed by me so you know what is what.
Some Points To NOTE:
You will find that I have started to tidy up the Band Plan in my SDR# for the UK because the one that comes with SDR# is a complete mess and I think was made for people in the USA as opposed to the UK you can just replace that with the original should you not like it.
I have also added New Groups to the Frequency Manager these are Frequencies I have found in my own area (Leicester) so may or may not be active in your area, the Groups I have added are.
FM Radio (FM Radio Stations)
2M HAM (So far just 1 2m Ham Frequency)
security (Lots of active DMR, PMR channels etc that are in my area, ranging from about 446 - 460 mHz)
Again you can remove the Frequencies from a group or regroup them all from inside SDRSharp's Frequency Manager, see the icons at the top of the Frequency Manager.
Enjoy.
OK the forum says the file is to large so I will upload it to my server and PM you a link to download it