In case anyone made the mistake I did.
Originally I searched the Manual for 'IF OUTPUT'. No references to that so I assumed it had not been incorporated.
In fact the AR-DV1 DOES have an IF out for use with external software, via the 3.5 mm AUX jack on the back.
I have not tried it yet, but will be doing so, as it may open a lot of other possibilities.
Here you can discuss radio related computer software and computer control of radio equipment.
2 posts • Page 1 of 1
- Top Poster
- Posts: 1930
- Joined: 01 Jun 2004, 09:00
- Location: Cheshire
You may find it only works on certain bands. I have the AR5001d and because it uses direct sampling up to 25 MHz, there is no IF up to this frequency. Above 25 MHz, the IF output works a treat.
If it ain't broke, it soon will be!
Who is online
Users browsing this forum: No registered users and 3 guests