Hi all my mate has just setup a radio for mobile but has a problem.he got a Tri mag mount and a thunderpole scarlet warrior bull whip.he also has a full 1/4 tank whip.problem is the bull whip will only cover the UK 40 block,when he tried it on the midblock the swr goes to nearly 2.0.he pull the top whip as far as he can and still the same.also the tank whip goes off the scale.tried the coax with multi meter and that's fine.not Shure what he can do?any ideas
Regards
High swr with Tri mag mount
-
- Regular
- Posts: 48
- Joined: 01 Mar 2018, 07:26
- Call Sign: Fb009
- Location: Southam/Warwickshire
- Mudslinger
- Legend
- Posts: 7493
- Joined: 28 Jul 2010, 07:11
- Location: Oxfordshire
Re: High swr with Tri mag mount
Have you checked the connection at the manet end of the coax?
The tank whip at least should give a very good SWR across many channels with no adjustment.
The tank whip at least should give a very good SWR across many channels with no adjustment.
Mudslinger - Simon
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.
-
- Regular
- Posts: 48
- Joined: 01 Mar 2018, 07:26
- Call Sign: Fb009
- Location: Southam/Warwickshire
Re: High swr with Tri mag mount
Hi Simon,I will message him that.many thanks
- Mudslinger
- Legend
- Posts: 7493
- Joined: 28 Jul 2010, 07:11
- Location: Oxfordshire
Re: High swr with Tri mag mount
Check there is continuity between the outer of the coax/PL259 and the magnet base and continuity betwen the PL259 centre and the antenna stud, but not between the two.
Some new magmounts are very poor in this respect, especially if they came from Maplins/Moonraker.
Some new magmounts are very poor in this respect, especially if they came from Maplins/Moonraker.
Mudslinger - Simon
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.
-
- Legend
- Posts: 8666
- Joined: 23 Jan 2010, 19:26
- Location: Bristol-ish
Re: High swr with Tri mag mount
Try a temporary ground/earth wire from the trimag's frame and the car body, say onto a scraped-down metal bolt on the door hinges for example. It might not make a difference, but if it does then something may not be quite right.
Last edited by The Collector on 24 Apr 2018, 11:07, edited 1 time in total.
-
- Regular
- Posts: 48
- Joined: 01 Mar 2018, 07:26
- Call Sign: Fb009
- Location: Southam/Warwickshire
Re: High swr with Tri mag mount
Hi there lads,yes he has tried the coax with a meter and that's fine to the base and where the antenna screws in.its a strange one especially with two antennas
- andrew013
- Top Poster
- Posts: 1987
- Joined: 17 Aug 2010, 12:41
- Call Sign: 26AT013
- Location: gateshead tyne and wear
Re: High swr with Tri mag mount
whats the car try moving magmount around the roof say corner middle rear middle etc can make a differnce but scarlet warriors are normally pretty eay to swr whip all the way down and a few mm up job done , saying that a swr of 2 is f all really
on air,tyne&wear,northumberland,durham,holy island,eu120+eu124 and anywhere from gateshead/north wales
scrap uk 40 give cbers L/M/Hcalling on 27.355/555 usb qsy 27.015 lsb/410 usb cb radio is for life not just for profits
i do cb radio not 11mtres,countrys worked 2015 with imax 2000 72
scrap uk 40 give cbers L/M/Hcalling on 27.355/555 usb qsy 27.015 lsb/410 usb cb radio is for life not just for profits
i do cb radio not 11mtres,countrys worked 2015 with imax 2000 72
- ch25
- Top Poster
- Posts: 1680
- Joined: 03 Dec 2016, 11:07
- Call Sign: Lemmy
- Location: Poland
Re: High swr with Tri mag mount
Seems fine. Below screenshot from antenna analyser. Single mag mount, centre of roof.
Put magnet at the middle of the roof and open doors. SWR will go down. Tested.
Chris
WE ARE MOTÖRHEAD, AND WE PLAY ROCK N' ROLL
You can't have too many antennas...
You can't have too many antennas...