Hi All .
Just to add to my other post on the rubber feet . Does anyone know the size of the big side screws that the Uniden home bases use ? They usually have a washer on them . E.g Madison , Washington , Franklin , Cobra 2000 etc.
Thx in advance .
Sammy
Home base big side screws
- cb4ever104
- Legend
- Posts: 6561
- Joined: 28 Jul 2011, 21:26
- Location: España
Home base big side screws
30TM060
Paul aka "Sammy". (108) PY60 Old Paisley DX Group (RIP Rab Markie)
Ex GM0 , now EA5 .
Handle "Fortune Hunter" back in "the day"
Radios ....? Anything that says "TAIWAN R.O.C" on the back.
Paul aka "Sammy". (108) PY60 Old Paisley DX Group (RIP Rab Markie)
Ex GM0 , now EA5 .
Handle "Fortune Hunter" back in "the day"
Radios ....? Anything that says "TAIWAN R.O.C" on the back.
- Mudslinger
- Legend
- Posts: 7490
- Joined: 28 Jul 2010, 07:11
- Location: Oxfordshire
Re: Home base big side screws
I am pretty sure they are M6x1.0
Mudslinger - Simon
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.
- cb4ever104
- Legend
- Posts: 6561
- Joined: 28 Jul 2011, 21:26
- Location: España
Re: Home base big side screws
Thanks for replying Simon. Ok. I'll ser if I can track some down on Ebay. I presume you meant M6x10.
Cheers m8!
Cheers m8!
30TM060
Paul aka "Sammy". (108) PY60 Old Paisley DX Group (RIP Rab Markie)
Ex GM0 , now EA5 .
Handle "Fortune Hunter" back in "the day"
Radios ....? Anything that says "TAIWAN R.O.C" on the back.
Paul aka "Sammy". (108) PY60 Old Paisley DX Group (RIP Rab Markie)
Ex GM0 , now EA5 .
Handle "Fortune Hunter" back in "the day"
Radios ....? Anything that says "TAIWAN R.O.C" on the back.
- Mudslinger
- Legend
- Posts: 7490
- Joined: 28 Jul 2010, 07:11
- Location: Oxfordshire
Re: Home base big side screws
No M6x1.0, the 1.0 is the thread pitch.
That is the standard thread pitch for regular M6, so if it does say M6 x 10 that will refer to the length. I am pretty sure that would be about right.
I may have a couple of the original screws kicking about, I will have a look tomorrow.
That is the standard thread pitch for regular M6, so if it does say M6 x 10 that will refer to the length. I am pretty sure that would be about right.
I may have a couple of the original screws kicking about, I will have a look tomorrow.
Mudslinger - Simon
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.
26TM274
26CT612
There is no such thing as a Fidelity 1000 which is too good to scrap.