INFO NEEDED ON A ZETAGI MOD 500

[Ashtec]

Hi all im needing some info on a Zetagi mod. 500 power swr meter.

Ive had one sent in for repair the swr side of it work's but the power meter is'nt moveing ive ripped the lid off it and i can see a burnt out resistor on the pcb.

Now the biggest problems is i dont know the value of the resistor thats burnt out ive looked all over the net looking for a diagram of the pcb as well as looking for a parts list for it.

So can any one help me on this even a pic of the in side of one will help me...........................

[zephyr]

[email protected]
If you need a schematic the above address is what I always use with good results.

[Ashtec]

http://[email protected]
If you need a schematic the above address is what I always use with good results.

Sorry to ask is this a email address i when i go on the link it put's me on to email............

[zephyr]

It is, just ask them for the schematic diagram for the Zetagi 500 meter.
It's worked for me in the past when I can't find one on the net.

[Ashtec]

It is, just ask them for the schematic diagram for the Zetagi 500 meter.
It's worked for me in the past when I can't find one on the net.

Thanks i will give it a go....................

[zephyr]

Paul,
Did you get the information you needed from Zetagi ?.

[Ashtec]

NOPE I DIDNT GET AN EMAIL BACK MATE IM STILL NEEDING INFO OR A PIC OT THE PCB................

[Nitehawk]

Will this help.

[Ashtec]

Will this help.

Nope that's a valve amp mate a ZETAGI 135 i think by the look's of that...................



10 points for trying mate thank's

[Nitehawk]

Theirs a b400 schematic on cb tricks any good?

[Clint]

draw the circuit around and including the resistor and I will take a guess at its value

[zephyr]

That B400 schematic is the one I got from Zetagi and re-drew for CBTricks.
It's a burner not a meter.

[Ashtec]

Has any go a pic of one...........................

[Ashtec]

Any one........................

[Ashtec]

Im still needing info on this as now the wires have fell off it as it keep's geting moved about the work shop..........