Page 1 of 1

Scottish codeplug required.

Posted: 04 Sep 2017, 20:19
by gmham
Anyone fancy doing me a codeplug for a few freqs off interest I have for my newly purchased Retevis rt3 TYT ( md380 clone) basically looking for the uhf Scottish amateur radio codeplug plus 8ch 446 digital / 446 digital and a few other spot freqs shop watch etc ( have the required dmr info)

Cheers.
John

Would be very much appreciated.

Re: Scottish codeplug required.

Posted: 05 Sep 2017, 13:14
by mr_h4ck3rm4n
hi john, there is a good generic codeplug on the gb7dd site, 446 , dmr 446, and local repeaters on, just needs tweeking for gb7tt ect

Re: Scottish codeplug required.

Posted: 05 Sep 2017, 14:25
by gmham

Re: Scottish codeplug required.

Posted: 05 Sep 2017, 18:33
by mr_h4ck3rm4n

Re: Scottish codeplug required.

Posted: 05 Sep 2017, 20:35
by gmham
Okay cheers will have a look and that's got the 446mhz channels on as well yep?
One thing when entering the TG details for instance my local shop watch uses a TG off 58 and one uses 16777215 where in the codeplug Editor software would you enter these details particular numbers ? Is this the group list entry panel ? if so it only has group list 1 or group list 2 from the drop down list ?

Re: Scottish codeplug required.

Posted: 06 Sep 2017, 05:02
by gmham
Added to the above can someone point me in the right direction to the most up to date alternative firmware I can load on my RT3 to give both promiscuous mode and to show list off dmr ID plus amateur radio callsign ?

Re: Scottish codeplug required.

Posted: 08 Sep 2017, 10:04
by gmham
Best alternative FW for non GPS md380 ? Link?

Re: Scottish codeplug required.

Posted: 09 Sep 2017, 17:09
by scottyboy

Re: Scottish codeplug required.

Posted: 11 Sep 2017, 18:42
by gmham
Thanks mate all done !!