Scottish codeplug required.

[gmham]

Anyone fancy doing me a codeplug for a few freqs off interest I have for my newly purchased Retevis rt3 TYT ( md380 clone) basically looking for the uhf Scottish amateur radio codeplug plus 8ch 446 digital / 446 digital and a few other spot freqs shop watch etc ( have the required dmr info)

Cheers.
John

Would be very much appreciated.

[mr_h4ck3rm4n]

hi john, there is a good generic codeplug on the gb7dd site, 446 , dmr 446, and local repeaters on, just needs tweeking for gb7tt ect

[gmham]

Okay cheers is this the one ? http://www.gb7dd.co.uk/wp-content/uploa ... MM0BUH.zip

[mr_h4ck3rm4n]

http://www.gb7dd.co.uk/wp-content/uploa ... MM0RBR.rdt

[gmham]

Okay cheers will have a look and that's got the 446mhz channels on as well yep?
One thing when entering the TG details for instance my local shop watch uses a TG off 58 and one uses 16777215 where in the codeplug Editor software would you enter these details particular numbers ? Is this the group list entry panel ? if so it only has group list 1 or group list 2 from the drop down list ?

[gmham]

Added to the above can someone point me in the right direction to the most up to date alternative firmware I can load on my RT3 to give both promiscuous mode and to show list off dmr ID plus amateur radio callsign ?

[gmham]

Best alternative FW for non GPS md380 ? Link?

[scottyboy]

http://md380.tools/

[gmham]

Thanks mate all done !!